Jungheinrich DFG 660 Operating Instructions Manual page 116

Safety instructions for sideshifter and fork adjuster attachments
WARNING!
When using multi fork adjusters (multi pallet clamps), restricted visibility and reduced
lateral tilt resistance can result in accidents.
Adapt the travel speeds to the visibility and load.
Make sure you have enough visibility when reversing.
Safety instructions for clamping attachments (e.g. baling clamps, barrel
clamps, grabs etc.)
WARNING!
Falling loads can cause accidents
This can result in malfunctions and the load can fall accidentally.
Clamping attachments may only be added to trucks which have a button to enable
additional hydraulic functions.
Clamping attachments must only be operated on trucks will auxiliary hydraulics HF4
or HF5.
When connecting the attachment make sure that the hydraulic lines of the
attachment are connected to the right ports, (see "Fitting additional attachments" on
page 122).
Safety instructions for rotary attachments
WARNING!
A non-centred centre of gravity can result in accidents
When using rotary devices and non-centred loads, the centre of gravity can be
displaced from the centre with a high risk of accidents.
Adapt the travel speed to the load.
Lift the load from the centre.
Safety instructions for telescopic attachments
WARNING!
Accident risk from increased tipover hazard and reduced residual capacity
There is a greater tipover risk with extended telescopic attachments (e.g. reach
carriages, telescopic forks, telescopic crane booms).
Only use the telescopic function for stacking and retrieving.
Always retract the attachment fully during transport.
Adapt the travel speed to changed load centre of gravity.
117