®
3.1 2N
Use a PC equipped with any web browser to configure 2N
You have to know the IP address of your device to log in to the integrated web server.
By default, 2N
obtains the IP address automatically if a properly set DHCP server is available in your
LAN. If no such DHCP server is available, you can operate 2N
static IP address mode. Refer to the 2N
configuration details.
If your device remains inaccessible (you have forgotten the IP address, or the LAN
configuration has changed, for example), change the LAN settings using the buttons
on the device.
Static IP Address Setting
Follow the instructions below to enable the static IP address mode:
Note: The 1, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first
sound signal for security reasons. The inter-digit delay may be 2s at most.
The device will have the following network parameters after restart:
IP address:
Network mask:
Default gateway:
Dynamic IP Address Setting
Follow the instructions below to enable automatic getting of network parameters from
the DHCP server:
Helios IP Force Configuration
Launch your web browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
Log in using the Admin user name and 2n password.
®
Helios IP Force is switched into the dynamic IP address mode, i.e. it
®
Connect 2N
Helios IP Force to the power supply (or, disconnect and
reconnect it if already connected).
Wait for the first acoustic signal
Press buttons 1, 1, 1, 2, 2, 3 sequentially.
The acoustic signal
Wait until the device is restarted automatically.
192.168.1.100
255.255.255.0
192.168.1.1
®
Connect 2N
Helios IP Force to the power supply (or, disconnect and
reconnect it if already connected).
2N® Helios IP Force Configuration
®
Helios IP Configuration Manual for
.
indicates mode switching.
®
Helios IP Force:
®
Helios IP Force in the
3.1
31
Need help?
Do you have a question about the Helios IP Force and is the answer not in the manual?