Button Tags - Insertion And Replacement; Tag Printing; Tag Inserting / Replacing Instructions - 2N Helios IP Force Installation Manual

2.4 Button Tags – Insertion and
Replacement

Tag Printing

1.
2.
Note


Tag Inserting / Replacing Instructions

2N® Helios IP Force provides an intuitive, easy
access to the name plates. The tags are easy to
insert and replace even without a manual. You
need not remove the front panel and thus are not
exposed to the risk of loss of components while
replacing the tags.
1. Loosen the name plate screw using the
2. Remove the used or blank name tag and
7. Close the name plate window and tighten
8. Check the click effect of the buttons: if the
Button Tags – Insertion and Replacement
Every 2N® Helios IP Force delivery includes a sheet of translucent foil, which
can be laser-printed. Cut the printed foil and insert the tags in the name
plates.
Every name plate includes a piece of foil, which can be written over manually,
using a waterproof permanent marker, if necessary.
Always use waterproof foil (enclosed or other) for the tags. Never use
paper or ink jet printing to avoid damage due to water leakage!
wrench enclosed, for example. You can
open the name plate window like a door
without losing the tightened screw.
insert a new tag.
the screw appropriately.
button fails to click properly when pressed
(when moved by approx. 0.5 mm), the tag
is too thick or thin. Make sure that the
button clicks when you press it on both
ends.
2.4
28