Dlci Mapping/Active - ADTRAN Express L128FP User Manual

Chapter 3. Terminal Menu Operation and Structure
tive. These active DLCIs will attempt to determine the IP and IPX ad-
dresses on the other end of the virtual circuit using Inverse ARP
(IARP). If there is a response, the network learned will be added to the
router tables and the virtual circuit will be treated as an unnumbered
interface. Bridge connections are made using bridge group 1.
When more than one DLCI mapping is listed, the Express L128FP will
try to match the DLCIs learned from the Frame Relay switch with the
DLCI values in the map. If there is a match, the protocols specified in
the map are used. However, if an active DLCI is not in the list, it looks
for an entry that has 0 in the DLCI field. This entry is considered the
default entry to use when no match occurs. If this default entry is not
present, the Express L128FP falls back to using IARP (as discussed in
the previous paragraph) to determine the protocols to use with that
particular virtual circuit. If a static maintenance protocol is used, at
least one DLCI mapping must be specified.

DLCI Mapping/Active

Write security: 3, Read security: 5
When this parameter is set to Yes (def), the mapping is used to deter-
mine the protocols used. If set to No, the Express L128FP will ignore
the virtual circuit with this DLCI.
3-34
To insert a new profile, press the
column. A new inserted profile will always be set up with
the default parameters. To copy parameters from an old
profile to this newly inserted profile, use the copy (
paste ( ) keys. Entire configuration trees can be copied
P
with this method.
To delete an unused profile, use the
is over the number in the Num column. Once deleted, the
profile is gone permanently as soon as the DLCI Mapping
is saved. Items may be deleted when DEL appears below
the status bar.
Express L128FP User Manual
key when over the Num
I
key when the cursor
D
61202070L4-20
) and
C