Automatic / Manual Transmission Jumper - Code Alarm professional series PROCOMP Installation Manual

Custom PIN Code Programming
Programming your Pin Code (pin code must be two digits).
1. Turn the ignition ON.
2. Press and hold the programming button for 10 seconds, the
system will chirp 3 times.
3. Advance to Feature Bank 3, (5 chirps).
4. Press and hold TRUNK button for three seconds to enter pin code
programming, the siren will chirp twice and the LED will flash twice.
5. Enter the first digit by pressing the LOCK button 1-9 times.
6. Enter the second digit by pressing the UNLOCK button 1-9 times.
7. Press and hold TRUNK button for three seconds to confirm digit
entry and exit programming, the system will give one long chirp and
report entry by flashing the LED.
If the new pin code has been accepted (example pin code is 87), the unit will
report back by flashing the LED 8 times to indicate the first digit, pause and then
flash 7 times indicating the second digit.
Example: If the desired pin code is 87, during step 5 you will press the LOCK
button 8 times and during step 6 you will press the UNLOCK button 7 times.
NOTE: Custom Code must be turned ON in feature bank 3 before a pin code can
be programed. The default setting for this feature is OFF.

Automatic / Manual Transmission Jumper

For safety reasons the system default is manual transmission mode. To enable
automatic transmission mode, change the position of the Transmission Jumper
from Manual to Auto.
2012 Audiovox Electronics Corporation. All rights reserved. 31