Assembling The Arm Springs; Assembling The Push Through Bar Spring; Assembling The Safety Chain - Peak Pilates Deluxe Reformer Assembly Manual

Assembling the Arm Springs

To assemble the Arm Springs (444 mm (17.5 in) long):
1. Using the Double Ended Clips, attach Arm Spring to
each side of the Roll Down Bar.
2. Store the Arm Springs by hooking them to the upper
eye bolts located in the back of the Tower.

Assembling the Push Through Bar Spring

To assemble the Push Through Bar Spring:
1. The Push Through Bar Spring is covered with a vinyl
sleeve. It is stored stretched between the two eye
bolts that are located at the bottom of the Tower.

Assembling the Safety Chain

To assemble the Safety Chain:
1. Using the Safety Link, attach one end of the chain to
the outside eyebolt on one side of the Riser Cap.
2. Attach the other end to the ring on the Push Through Bar.
Warning: Tighten the Safety Link locks.The Safety Chain is to remain attached to the Riser
Cap and the Push Through Bar at all times. Do not remove the Safety Chain under any circumstances.
16 Peak PilateSystem Assembly Guide
®