Adjusting The Risers; Installing The Jump Board (If Available); Installing The Long/Short Box - Peak Pilates Deluxe Reformer Assembly Manual

Adjusting the Risers

The Risers have 7 scaled and 1 stored positions. The
Riser positions are scaled so that both Risers can be
easily adjusted to the same height.
To adjust the Risers:
1. Pull the Riser Pull Pin and move the Riser up or down to the desired position.
2. Release the Riser Pull Pin to lock.
3. Set the Riser on the other side of the machine to the same position.
Caution: Make sure that the Riser Pull Pin is engaged before beginning any exercises.
Installing the Jump Board
To install the Jump Board perform the following:
1. Lower the Footbar and Support Bar.
2. Slide the Jump Board pegs into the holes located on
the Standing Platform with the padded end facing the Carriage.

Installing the Long/Short Box

Install the Long/Short Box as follows:
To use it as a Long Box:
1. Place the Head Rest in the Flat position and rest the Footbar
and Support Bar on the Standing Platform.
2. Place the box lengthwise on the Carriage surface,
butting one end against the Shoulder Pads.
26 Peak PilateSystem Assembly Guide
®