ASSEMBLY
Attach the Springs
Attach the reformer springs to the anchor bar on the
7
underside of the carriage. The open part of the hook
should be facing away from the carriage.
8
Remove the shipping spacers located between the
frame of the carriage and the aluminum rails.
9
With two people holding the reformer, turn the unit
over onto its legs.
Assemble the Shoulder Pads
Place the shoulder pads into position, aligning the
10
mounting holes. Secure using Flat Head Socket
Screws. Partially tighten all four screws. Once all four
are partially tightened, go back and fully tighten with
the provided 5mm allen
USE.
Assemble the Risers and Ropes
Pull out and hold the riser pull pin. Insert each riser
11
into its respective bushing and release the pull pin.
Make sure that the riser has engaged the pin and test
by pulling up before the rope is installed.
PeakPilates Fit Owners Manual-2021.indd 11
PeakPilates Fit Owners Manual-2021.indd 11
wrench.NGAGED BEFORE
Anchor Bar
Riser Pull Pin
www.peakpilates.com
Flat Socket
Head Screw
11
8/9/21 9:42 AM
8/9/21 9:42 AM