Bellfires UNICA 200 L Instruction For Use & Installation Instructions page 16

Bellfi res
1.8 USING THE APPLIANCE FOR THE FIRST TIME
The gas fi re is coated with a lacquer layer resistant to high temperature.
During the fi rst hours of operation, the burning in of the lacquer may result in an
unpleasant smell. This is harmless, however. Operating the gas fi re at full capacity for a
few hours, while ventilating the room, will eliminate the smell. Moreover, deposits may
form on the inside off the glass; these can be removed with a dry cloth when the gas fi re
has cooled down.
1.9 DAILY MAINTENANCE
• Regulary check that the air supply is still open.
• Ensure that as little dust, and as few particles of cigarette smoke, candles and
oil lamps as possible pollute the air in the room in which the appliance is used.
Heating of these particles by the convection system of the appliance could lead to
discoloration of the walls and ceiling. It is therefore very important to ensure that the
room in which the appliance is located is suffi ciently ventilated. Regularly remove any
dust deposits from behind the control fl ap by means of a vacuum cleaner.
Important: If the glass is broken or cracked, it must be
immediately replaced before operating the
gas fi re again.
• If anything is spilt on the fi re, switch it off immediately and wait for it to cool down
suffi ciently before cleaning. Never use scouring powder, aggressive cleaners or fi re
polish on the gas fi re. Use only a dry lint free cloth.
• Heat resistant lacquer in aerosols can be obtained from your distributor.
During the yearly maintenance, the lacquer can be used to repair small areas of
damage.
The installation must only be carried out by a
"Gas Safe Register" registered installation engineer.
16
IMPORTANT
Instructions for use & Installation instructions
English