Bellfires UNICA 200 L Instruction For Use & Installation Instructions page 26

Bellfi res
5 POSITIONING THE CERAMIC LOG SET
The appliance is delivered with a set of artifi cial wooden logs and embers (and vermicu-
lite granules for the NATURAL GAS appliances only!).
Important : • Do not place any logs, embers or vermiculite granules
against the pilot fl ame burner. Make sure that the pilot
fl ame can burn freely over the main burner. Only in this
way is proper ignition of the main burner ensured.
• The burner bed (with embers/vermiculite) and the
positioning of the logs must not be changed.
POSITIONING THE CERAMIC LOG SET:
NATURAL GAS APPLIANCE:
1. Distribute the vermiculite granules (1x 10 gram) evenly over the burner
(not in front of the pilot light).
2. Carefully remove the embers (2x 125 gram) from the packaging and place
them evenly on and around the burner.
Note ! Small embers and their residue should not be scattered on
the burner. This can cause a blockage on the burner orifi ces.
3. Place the two rear logs behind the burner with the carbon side to the front.
4. Position the remaining logs. (See fi gure 11.)
PROPANE APPLIANCE:
The positioning of the log set is the same as that for the natural gas appliance described
above. However with the log set, only one bag (1x 125 gram) of embers may be placed
on and around the burner.
Vermiculite granules are not permitted and are therefore not supplied with appliances
that use propane.
Figure 11: Log set UNICA 200 L/R / UNICA 300
26
Instructions for use & Installation instructions
English