Bellfires UNICA 200 L Instruction For Use & Installation Instructions page 9

Bellfi res
1.4 IGNITING THE FIRE
• Open the gas supply valve in the gas pipe to the fi re.
• Lock the slider into "l" position.
• Turn the thermostat knob to the ignition position "«" and then push the knob in.
• While keeping the thermostat knob pushed in, press the ingition button a few times to
ignite the pilot light. Check through the glass that the pilot light has been lit.
• When the pilot light is lit, keep the thermostat knob pushed in for a further 10 seconds,
after which it can be released.
Important : If the pilot fl ame goes out, then wait for at
least 5 minutes before repeating the above
procedure.
• By turning the thermostat knob to the required setting and/or pushing the slider into a
downward position: the burner will now ignite.
1.5 TURNING OFF THE FIRE
• Turn the thermostat knob to the ignition position "«".
• Lock the slider to the "l" position.
The burner will now be fully extinguished.
If the thermostat knob is turned back to the "1" position, then the burner will continue to
operate for as long as the room temperature remains below 13°C.
1.6 EXTINGUISHING THE PILOT LIGHT
• Extinguish the pilot by setting the thermostat knob to the "l" position.
• If the gas fi re is not going to be used for a long period of time, it is recommended to
close the gas supply valve to the fi re.
Important : If the pilot fl ame goes out for any reason,
wait for 5 minutes before attempting to
re-light it.
• If the pilot light frequently goes out, then please contact your installer.
Instructions for use & Installation instructions
English
9