Bellfires UNICA 200 L Instruction For Use & Installation Instructions page 24

Bellfi res
Cover plate
Figure 10: Unica 300
Installing the gas fi re insert should be carried out in the following order:
1 FITTING THE OUTER CASING
Place the outer casing into the fi replace opening and position it horizontally and
vertically level to the wall. The casing must also be level.
Check that the gas supply pipe has been fed through the opening provided at the rear
or at the bottom side.
If necessary, loosen the electrical supply cable from the connector, and guide the cable
through the special openings to the wall socket, on which, during installation, there must
be no tension.
Slightly lower the (insulated) aluminium or (fl exible) stainles steel pipe (Ø100 mm),
which is made through the chimney, through the opening at the top of the outer casing.
Attach the pipe to the fl ue spigot and push it back upwards again.
The fl ue spigot can now be fi xed to the casing from the inside using self tapping screws.
24
Control-unit
Front
Door
Side-cover
Operating hatch
Instructions for use & Installation instructions
English
Flue spigot
Outer casing
Inner shell /
Combustion chamber