Bellfires UNICA 200 L Instruction For Use & Installation Instructions page 13

Bellfi res
1.7.5 Extinguishing the fi re
Turn knob B, possibly with the remote control, fully to the right to the l -symbol and/or
turn the control knob A to the right until the stop ("small fl ame" symbol = pilot light
position).
The main burner will still burn for a few seconds, after which it will be extinguished
completely.
1.7.6 Set the display
• After connecting the batteries or when simultaneously pressing AUTO and TIMER,
the display will fl ash. You are now in "SET" mode.
• Press AUTO to switch from °F (and standard time) to °C (and military time) or
vice versa.
• The display will automatically return to manual mode after some time, but
you may immediately return to MAN by pressing the TIMER button.
1.7.7 Set the current time
• After connecting the batteries or when simultaneously pressing AUTO and TIMER,
the display fl ashes. You are in SET mode.
• Press to set the hour and
• Wait or press TIMER to return to MAN mode.
1.7.8 Programming the desired temperature
• Press AUTO until display fl ashes.
• Press or to set the temperature.
• Wait or press AUTO to switch to automatic mode.
1.7.9 Programming the timer
• Press TIMER until P1
• Set the time for the beginning of the fi rst heating period by pressing
and for minute'setting.
• Press TIMER again; P1
Set the time for the end of the fi rst heating period.
• Press TIMER again to set the second heating period P2
(heat OFF).
• Store both heating periods by pressing TIMER again.
• If only one heating period is desired, program the same time for P2 and P1.
Instructions for use & Installation instructions
to set the minute.
fl ashes (heating period 1, heat ON)
appears on the display.
English
for hour
(heat ON) and P2
13