Bellfires UNICA 200 L Instruction For Use & Installation Instructions page 15

Bellfi res
1.7.15 Replacing the batteries
The batteries of the hand-held transmitter and reciever have a lifespan of approximately
one year.
If BATT appears in upper right corner of the display, please change the battery from the
hand-held transmitter.
If the LED of the reciever becomes faint, please change the battery from the reciever.
Hand-held transmitter:
• Open the cover at the back of the hand-held transmitter.
• Carefully remove the 9V block battery and release it from the contact maker.
Do not pull the wires!
• Connect the new battery and refi t. Close the cover.
Receiver:
• Remove the battery support from the housing and release it from the contact holder.
• Remove the batteries from the battery support.
• Place the 4 new batteries of 1,5V (type LR6 or AA) in the battery support as
indicated. The pressure spring always against the negative pole (-) of the battery.
Connect the battery support with the contact maker. Replace the support and close
the cover. Incorrect placement of the batteries or the battery support can lead to
irreparable damage to the electronics or the electric propulsion.
NOTE:
Please note, the placement of the transmitter (temperature sensor) is important to as-
sure proper temperature regulation. Generally, a more constant temperature will be as-
sured, if the transmitter is not too far from the gas appliance. Before switching to AUTO
or TIMER mode, press either knob
symbol appears in the transmitter display, the receiver's LED must illuminate).
Instructions for use & Installation instructions
or to verify the reception (when the SEND
English
15