Table of Contents
Advertisement
2.9.5 IDE Disk Drive Connectors
The system board is equipped with two shrouded PCI IDE headers
that will interface four Enhanced IDE (Integrated Drive Electronics)
disk drives. To prevent improper IDE cable installation, each shrouded
PCI IDE header has a keying mechanism. The 40-pin connector on
the IDE cable can be placed into the header only if pin 1 of the
connector is aligned with pin 1 of the header. You may enable or
disable the onboard primary or secondary IDE controller in the
Integrated Peripherals submenu ("VIA OnChip IDE Device" field) of
the BIOS.
Connecting the IDE Disk Drive Cable
1. If you are connecting two IDE drives, install the 40-pin connector
of the IDE cable into the primar y shrouded IDE header (J22). If
you are adding a third or four th IDE device, install the 40-pin
connector of the other IDE cable into the secondary shrouded
IDE header (J23).
2. Install the other 40-pin header connector(s) into the device with
the colored edge of the ribbon cable aligned with pin 1 of the
drive edge connector(s).
Note:
Refer to your disk drive user's manual for information about
selecting proper drive switch settings.
Primary IDE
(J22)
Secondary IDE
(J23)
Hardware Installation
2
29
Advertisement
Table of Contents
