Table of Contents
Advertisement
Wake Up Events
Move the cursor to this field and press <Enter>. The following fields
will appear.
USB Resume from S3
This field, when enabled, allows you to use a USB device to
wake up the system.
VGA
When set to On, the system will respond and wake up to any
VGA activity.
LPT & COM
Select the port you would like the system to respond and wake
up when an event occurs on that port.
HDD & FDD
When set to On, the system will respond and wake up to any
hard drive or floppy drive activity.
PCI Master
When set to On, the system will respond and wake up to any
PCI or bus master activity.
PowerOn by PCI Card
This field should be set to Enabled only if your PCI card such as
LAN card or modem card uses the PCI PME (Power
Management Event) signal to remotely wake up the PC. Refer to
the card's documentation for more information.
Resume On LAN/Ring
This field supports two functions.
•
When enabled, the system will power-on to respond to calls
coming through an external or internal modem. Refer to "Wake-
On-Ring Connector" in chapter 2 for more information.
•
When enabled, the LAN card in the system will allow the
network to power-on a Soft Power Down (Soft-Off) PC.
However, if your system is in the Suspend mode, you can wake
up the system only through an IRQ or DMA interrupt. Your
LAN card must support the remote wake up function. Refer
to "Wake-On-LAN Connector" in chapter 2 for more
information.
Award BIOS Setup Utility
3
69
Advertisement
Table of Contents
