Table of Contents
Advertisement
Super IO Device
Move the cursor to this field and press <Enter>. The following fields
will appear.
Onboard FDC Controller
Enabled
Enables the onboard floppy disk controller.
Disabled
Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
The system will automatically select an I/O address
for the onboard serial por t 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
manually select an I/O address for the onboard
serial port 1 and serial port 2.
Disabled
Disables the onboard serial port 1 and/or serial
por t 2.
UART2 Mode Select
The system board supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J11) and the COM 2 (J2) serial por t at the same time. If
you are using the COM 2 serial port, make sure this field is set
to Normal.
To use the IrDA function, follow the steps below.
1. Connect your IrDA cable to connector J11 on the system
board.
2. Set the "UART2 Mode Select" field to the type of IrDA
standard supported by your IrDA peripheral/device (IrDA or
ASKIR). For better transmission of data, your IrDA peripheral
device must be within a 30
meter.
3. Set the "RxD TxD Active" and "IR Transmission Delay" fields
appropriately.
RxD, TxD Active
The options are Hi, Lo; Lo, Hi; Lo, Lo; and Hi, Hi.
Award BIOS Setup Utility
Allows you to
o
angle and within a distance of 1
3
63
Advertisement
Table of Contents
