Table of Contents
Advertisement
2
Hardware Installation
Adding a Second IDE Disk Drive
When using two IDE drives, one must be set as the master and the
other as the slave. Follow the instructions provided by the drive
manufacturer for setting the jumpers and/or switches on the drives.
The system board supports Enhanced IDE or ATA-2, ATA/33,
ATA/66, ATA/100 and ATA/133 hard drives. We recommend that
you use hard drives from the same manufacturer. In a few cases,
drives from two different manufacturers will not function properly
when used together. The problem lies in the hard drives, not the
system board.
30
Important:
If you encountered problems while using an ATAPI CD-ROM
drive that is set in Master mode, please set the CD-ROM drive
to Slave mode. Some ATAPI CD-ROMs may not be recognized
and cannot be used if incorrectly set in Master mode.
Advertisement
Table of Contents
