Table of Contents
Advertisement
2
Hardware Installation
2.9.14 Wake-On-LAN Connector
The Wake-On-LAN connector is used to connect to a LAN card
that has the same connector. This function will allow the network to
remotely power-on a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can power-on the system
only through an IRQ or DMA interrupt.
To use the Wake-On-LAN function, you must enable "Resume on
LAN/Ring" ("Wake Up Events" field) in the Power Management
Setup of the BIOS. Your LAN card package should include a cable.
Connect one end of the cable to the wakeup header on the card
and the other end to location J19 on the system board. The
network will detect Magic Packet and assert a wakeup signal to
power-up the system. Refer to the add-in card's manual for details.
Note: Your LAN card must support the remote wake up function.
42
Pin
1
2
3
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
1 2 3
Wake-On-LAN
(J19)
Function
+5VSB
Ground
WOL
Advertisement
Table of Contents
