IBM eServer xSeries 455 Type 8855 Hardware Maintenance Manual And Troubleshooting Manual page 38

10. Press Esc to return to the Configuration Settings window. If you need to
11. Press Esc to return to the main window.
12. Use the arrow keys to select Exit Utility from the menu or press Esc to exit
13. Remove the CD from the drive.
Continue with "Installing Advanced System Management device drivers."
Installing Advanced System Management device drivers: You must install the
ASM device drivers for the server. The device drivers enable communication
between the Remote Supervisor Adapter and the server in which it is installed. You
can obtain the most current device drivers from the World Wide Web at
http://www.ibm.com/pc/support/.
Note: If you are installing device drivers manually, note the following requirements:
After you install the ASM device drivers, go to "Configuring the remote-control
password" to set the remote-control password.
Configuring the remote-control password: If you want to use the remote-control
features of the Remote Supervisor Adapter ASM Web interface, you must configure
the remote-control password using the Configuration/Setup Utility program.
To set up a remote-control password, complete the following steps:
1. Start the server.
2. From the EFI Firmware Boot Manager, select the Configuration/Setup Utility
3. Use the Up Arrow and Down Arrow keys (— and –) to select System Security;
4. Select Remote Control Security Settings; then, press Enter. The Remote
5. Enter the remote-control password that you will use each time you log in to the
6. Select Save New Remote Control Password; then, press Enter.
7. In the System Security window, press Esc.
28
IBM xSeries 455 Type 8855: Hardware Maintenance Manual and Troubleshooting Guide
Authentication Protocol
The default is CHAP then PAP. Make sure that the value in this field
matches your client settings.
For detailed information about the PPP settings, see the information about
configuring PPP access over a serial port in the Remote Supervisor Adapter
User's Guide on the IBM xSeries Documentation CD.
8. Press F6 to apply the changes.
9. Press Esc. After the Warning window opens, press Enter to restart the Remote
Supervisor Adapter.
configure the serial port, go to "Configuring the serial port for text-based
remote access" on page 25.
from the program.
v You must install the operating system on the server before you install the
ASM device drivers. For information about installing the operating system,
see the documentation that comes with the operating system.
v Before installing the ASM device drivers for the Remote Supervisor
Adapter, stop any system-management application.
program.
then, press Enter. The System Security window opens.
Control Security Settings window opens.
remote-control features of the Remote Supervisor Adapter ASM Web Interface.