IBM eServer xSeries 455 Type 8855 Hardware Maintenance Manual And Troubleshooting Manual page 34

10. Press Esc. After the Warning window opens, press Enter to restart the Remote
11. Press Esc to return to the Configuration Settings window. If you need to
12. Press Esc to return to the main window.
24
IBM xSeries 455 Type 8855: Hardware Maintenance Manual and Troubleshooting Guide
4. Type the following EFI command:
flash2
5. Use the Up Arrow and Down Arrow keys (— and –) to select Configuration
Settings; then, press Enter. The Configuration Settings window opens.
6. Use the arrow keys to select Ethernet Settings; then, press Enter.
The Ethernet Settings window opens, as shown in the following illustration.
Note: The settings in the window are only examples; your settings might be
different.
7. Use the arrow keys to navigate to each field. Your system administrator can
provide the information for the following fields:
Network Interface
The default setting is Enabled; verify that it is still set to Enabled.
IP Address
Type the IP address of the Remote Supervisor Adapter.
Subnet Mask
Type the subnet mask used by the Remote Supervisor Adapter. The
default value is 255.255.255.0.
Gateway
Type the IP address of the gateway.
Host Name
Type the host name of the Remote Supervisor Adapter. The default
host name is ASMA burned-in MAC address.
For detailed information about the Ethernet settings, see the Remote
Supervisor Adapter User's Guide on the IBM xSeries Documentation CD.
8. Change the DHCP Setting field to Disabled. The default setting is Enabled.
9. Press F6 to apply the change.
Supervisor Adapter.
configure the serial port, go to "Configuring the serial port for text-based
remote access" on page 25..