Hot-Replacing Dimms - IBM eServer xSeries 455 Type 8855 Hardware Maintenance Manual And Troubleshooting Manual

5. Close the DIMM access door.
6. If you have other options to install or remove, do so now.
7. Close the server cover. See "Completing the installation" on page 111.

Hot-replacing DIMMs

Complete the following steps to install a DIMM in your server with the server turned
on:
1. Read the safety information beginning on page 215 and "Installation guidelines"
2. Open the cover and verify that the memory hot-plug enabled LED on the DIMM
3. Open the DIMM access door and verify that the memory port LED is off before
98
IBM xSeries 455 Type 8855: Hardware Maintenance Manual and Troubleshooting Guide
DIMM slot 1
on page 77.
access door is lit before removing and replacing the DIMM.
Attention: When you handle static-sensitive devices, take precautions to
avoid damage from static electricity. For details about handling these devices,
see "Handling static-sensitive devices" on page 78.
replacing a DIMM. Then, open the retaining clip on each end of the DIMM
connector and remove the DIMM from the server.
DIMM slot 15
DIMM slot 14
DIMM slot 28