IBM eServer xSeries 455 Type 8855 Hardware Maintenance Manual And Troubleshooting Manual page 120

Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery:
1. Read the safety information beginning on page 215 and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove fans 3 and 4 from the server (see "Replacing fan 3 or 4" on page 108
4. Remove the battery:
5. Insert the new battery:
110
IBM xSeries 455 Type 8855: Hardware Maintenance Manual and Troubleshooting Guide
on page 77. Follow any special handling and installation instructions supplied
with the replacement battery.
all external cables from the server; then, open the cover (see "Opening the
cover" on page 84 for details).
for details).
a. Use one finger to press the top of the battery clip away from the battery.
b. Lift and remove the battery from the socket.
a. Use one finger to press the top of the battery clip away from the battery.
b. Press the battery into the socket until it clicks into place. Make sure that the
battery clip holds the battery securely.