IBM eServer xSeries 455 Type 8855 Hardware Maintenance Manual And Troubleshooting Manual page 102

4. Disconnect the short SCSI cable from the SCSI backplane and the SCSI
5. Install the ServeRAID adapter in a PCI-X slot (see "Installing an adapter" on
6. Locate the preinstalled SCSI cable; then, attach the connector on the cable to
7. Locate the connector on the opposite end of the SCSI cable and connect it to
8. Reinstall fans 3 and 4.
If you have other options to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 111.
92
IBM xSeries 455 Type 8855: Hardware Maintenance Manual and Troubleshooting Guide
connector on the I/O board; then, store this short cable in a safe place for future
use.
SCSI connector
on I/O board
SCSI backplane
page 88).
Preinstalled
SCSI cable
Connect to
SCSI backplane
the ServeRAID adapter.
the SCSI backplane.
Connect to
ServeRAID adapter