IBM eServer xSeries 455 Type 8855 Hardware Maintenance Manual And Troubleshooting Manual page 174

Error message/symptom
114B (SAL/EFI ROM checksum or Boot error.)
231B (I/O card fault, Video initialization error.)
062 (System failed three consecutive boot attempts.)
161 (CMOS battery failure.)
162 (NVRAM checksum error.)
163 (Time or Date Error.)
175 (I/O Card Fault: Bad EEPROM CRC#1.)
178 (I/O Card Fault: EEPROM not functional.)
185 (All boot options failed.)
187 (I/O Card Fault: VPD serial number not set.)
188 (I/O Card Fault: Bad EEPROM CRC#2.)
195 (CPU x: CPU slot x)
201 (Invalid memory configuration)
211 (Memory board error)
212 (Memory board port 2 SMI parity error)
213 (Memory board port 1 SMI parity error)
214 (Error on memory board port 1.)
215 (Error on memory board port 2.)
216 (Memory board error.)
220 (DIMM in slot n is not DDR and ECC)
164
IBM xSeries 455 Type 8855: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Update system firmware.
2. I/O board.
I/O board
1. Update server to latest levels.
2. I/O board.
3. Processor board.
4. Processor.
Battery
1. Battery
2. I/O board
1. Set time of day using the Configuration/Setup
Utility program.
2. Battery.
3. I/O board.
I/O board
I/O board
1. Set the startup sequence using the
Configuration/Setup Utility program.
2. I/O board.
I/O board
I/O board
Processor board
1. Verify DIMM installation order.
2. Reseat DIMMs, re-enable DIMMs, if necessary, using
the Configuration/Setup Utility program, and run
diagnostics.
3. Replace failing DIMM.
4. Memory board.
Memory board
Memory board
Memory board
1. Reseat DIMMs, re-enable DIMMs, if necessary,
using the Configuration/Setup Utility program, and
run diagnostics.
2. Replace failing DIMM.
3. Memory board.
1. Reseat DIMMs, re-enable DIMMs, if necessary,
using the Configuration/Setup Utility program, and
run diagnostics.
2. Replace failing DIMM.
3. Memory board.
Memory board
Replace with DDR ECC DIMM.