Option 2: In-Building Installation - Wilson Electronics Sleek 4G Manual

6 . Power up your Sleek 4G . Connect the
power cable to the mini-USB port on the
bottom of the Sleek 4G . Then insert the
adapter into the vehicle 12V DC power
source . Use only the supplied Wilson
Electronics power supply . While the Sleek
4G may remain on, leaving the Sleek 4G
on in a vehicle when it is not running may
discharge the battery in a day or two . Also
note that some 12V DC power sources
are shut down when the vehicle ignition is
turned to off . Use a Bluetooth headset, wired
hands-free device or speakerphone for talking
on the phone .

Option 2: In-Building Installation

Note: Home Office Accessory Kit sold separately
1 . Install the Outside Antenna to a window . For
best results:
• S elect a window on the side of the
building where you get the strongest cell
signal .
• A ttach the suction cup bracket (sold
separately) to the inside of a window so
the cable will reach the location of the
Mounting Bracket and Sleek 4G . Place
the bracket as high on the window as
possible .
N OTE: Many newer energy efficient dual
pane windows use a metal coating that may
decrease the strength of a cellular signal,
reducing the effectiveness of the Sleek 4G .
If you have dual pane windows, consider a
Wilson Electronics signal boost product that
provides an option for mounting an antenna on
an outside wall or roof of a building .
4
Need help?
2 .
3 .
4 .
www.WilsonElectronics.com
• W ith the bracket in place, attach the
magnet base of the antenna to the flat
surface of the bracket . The antenna must
be mounted vertically for the best signal .
Install the Mounting Bracket and Sleek 4G .
Put your Sleek 4G in the Mounting Bracket
(see instructions under Vehicle Installation)
and place it in a convenient location such as
a desk or table top in the room where you will
use the phone . The location should be at least
three feet from the Outside Antenna to avoid
oscillation (feedback) . Your cell phone must
be in the cradle for the Sleek 4G to amplify the
signal . Use a Bluetooth headset, wired hands-
free device or speakerphone for talking on the
phone .
Attach the antenna to the Sleek 4G .
Connect the cable from the Outside Antenna
to the antenna connector on the bottom of
the Sleek 4G . Do NOT plug in the power
supply (next step) until the Outside Antenna
cable is connected to the Sleek 4G .
Power up your Sleek 4G . Connect the
power cable to the mini-USB port on the
bottom of the Sleek 4G . Then insert the
adapter and power it on . Use only the
supplied Wilson Electronics power supply .
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST