Signal Booster Specifications - Wilson Electronics Sleek 4G Manual

All Wilson Electronics products are protected by Wilson Electronics 30-day money-back guarantee . If
for any reason the performance of any product is not acceptable, simply return the product directly to the
reseller with a dated proof of purchase .
Wilson Electronics Signal Boosters are warranted for two (2) years against defects in workmanship and/or
materials . Warranty cases may be resolved by returning the product directly to the reseller with a dated proof
of purchase .
Signal Boosters may also be returned directly to the manufacturer at the consumer's expense, with a dated
proof of purchase and a Returned Material Authorization (RMA) number supplied by Wilson Electronics .
Wilson Electronics shall, at its option, either repair or replace the product . Wilson Electronics will pay for
delivery of the repaired or replaced product back to the original consumer if located within the continental U .S .
This warranty does not apply to any Signal Boosters determined by Wilson Electronics to have been subjected
to misuse, abuse, neglect, or mishandling that alters or damages physical or electronic properties .
Failure to use a surge protected AC Power Strip with at least a 1000 Joule rating will void your warranty .
RMA numbers may be obtained by contacting Technical Support at 866-294-1660 .

Signal Booster Specifications

Model Number
Connectors
Antenna Impedance
Frequency
Power output for single cell phone (dBm)
3
Power output for single cell phone (dBm)
3
Noise Figure (typical downlink/uplink)
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance . The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware . The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase
coverage of authorized frequency bands only . If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected .
If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn
the power off on that band . For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1
minute . After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually
restarted by momentarily removing power from the Signal Booster . Noise power, gain, and linearity are maintained by the Signal Booster's
microprocessor .
Disclaimer: The information provided by Wilson Electronics, LLC is believed to be complete
and accurate . However, no responsibility is assumed by Wilson Electronics, LLC
for any business or personal losses arising from its use, or for any infringements
of patents or other rights of third parties that may result from its use .
U .S . Patent Nos .– 7,221,967; 7,729,669; 7,486,929; 7,409,186; 7,684,838; 7,783,318; 8,473,018; 8,583,034; 8,583,033
30-Day Money-Back Guarantee
2-Year Warranty
698-746 MHz, 746-787 MHz, 824-894 MHz, 1850-1990 MHz, 1710-1755/2110-2155 MHz
700 MHz Band 12
Uplink 24 .4
700 MHz Band 12
Downlink -26 .0
Copyright © 2014 Wilson Electronics, LLC All rights reserved .
3301 East Deseret Drive, St . George, UT 84790
web: www .WilsonElectronics .com
phone: 866-294-1660
Sleek 4G
460007
SMA-Female
50 Ohms
700 MHz Band 13 800 MHz
23 .1 24 .9
700 MHz Band 13 800 MHz
-27 .8 -27 .3
3 dB nominal
> 40 dB
5 .5 V 2 A
email: tech@wilsonelectronics .com
local: 435-673-5021
1900 MHz 1700 MHz
22 .7 22 .0
1900 MHz 2100 MHz
-26 .8 -28 .6
fax: 435-656-2432
111284_Rev01_03 .17 .14