In-Building Installation - Wilson Electronics SLEEK 2B5225 Installation Manual

In-Building Installation

Installing a Wilson Electronics Outside Antenna in a Building
Follow t he s pecifi c a ntenna i nstructions i ncluded w ith t he O utside A ntenna ( sold s eparately e xcept f or
certain kits). These instructions assume that you are using a Wilson Electronics Mini-Magnet Mount
Antenna and the optional suction cup window bracket.
To receive the best signal, select a window on the side of your building where your outside signal is the
strongest.
Attach the suction cup bracket to the inside of a window so that the cable will reach
the location of the Sleek. Place the bracket as high on the window as possible for
best performance.
Once t he b racket i s i n p lace, a ttach t he m agnet b ase o f t he a ntenna t o t he fl a t
surface of the bracket. Note: The antenna must be installed vertically. Signal
performance will be degraded if the antenna is not vertical.
Installing the Wilson Electronics Sleek
The Wilson Electronics Sleek may be placed in any convenient indoor location, such as a desk or
tabletop. The cell phone or data card must be in the cradle and a Bluetooth headset used for voice
communications.
Attaching the Antenna
Once you have selected the location for the Sleek, run the cable from the outside antenna and attach it
to the SMA connector on the bottom of the Sleek.
Note: The cell phone must be placed in the Sleek cradle to amplify properly.
Adapter Note: For optimal performance and to maintain a secure connection, we recommend
attaching the included velcro tab. If adapter becomes lose in the port, gently
squeezing the adapter end will restore a snug fit.
Warning: The Sleek and the Outside Antenna must have a minimum separation of 3 feet to
prevent oscillation.
Sleek a mplifi e s s ignal
to & from cell tower
IMPORTANT NOTICE
5
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Signal Booster in a Building
®
Outside Antenna
communicates
with cell tower
Sleek powered through surge
protected AC Power Strip
• It is very important to power your Signal Booster using a
surge protected AC Power Strip with at least a 1000 Joule
rating.
• Failure to do this will void your warranty in the
power surge or lightning strike.
Mon.- Fri. Hours: 7 am to 6 pm MST.
event of a