In-Building Installation - Wilson Electronics 2B1216 Installation Manual

!
Warning: Verify that both the Outside
Antenna and the adapter extension cable
are connected to the Signal Booster before
powering up the Signal Booster .
!
Warning: Use only a Wilson Electronics power
supply . Use of a non-Wilson Electronics product
could damage your equipment . It is very
important to power your Signal Booster using a
surge protected AC Power Strip with at least a
1000 Joule rating.
Testing a Wilson Electronics Signal Booster
To test your Signal Booster, go to a weak signal area where your cell phone registers only
1-2 bars without the Signal Booster turned on . Then, connect the Signal Booster to the
phone and you should see a signal improvement of 2 or more bars .
Note: Many phones take up to 30 seconds to reset the bar indicator.

In-Building Installation

To Outside Antenna
Lightning Connect to cell
phone or data
Surge Protector
card
(sold separately)
GSM High Power
Contact our Technical Support Team for more information at:
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com
Power Supply
Powerstrip Surge
Protector
This is the recommended install for in-building use .
866-294-1660 or tech@wilsonelectronics .com
Carefully insert the power cable .
Mon.- Fri. Hours: 7 am to 6 pm MST.
Wide Band
Directional Antenna
Point toward cell tower
4