SMA SUNNY ISLAND 8.0H Installation Manual page 82

7 Commissioning
17. Turn the button to the right.
☑ The Sunny Remote Control shows the last page
of Setup new device.
18. Press the button and confirm the question Done ?
with Y.
☑ The settings are adopted. The QCG asks about
connected slaves in the off-grid system.
19. For a single system, terminate Setup Slaves ? with N.
☑ The off-grid inverter switches to standard mode and the QCG is terminated.
20. For a single-cluster system, confirm Setup Slaves ? with Y.
21. Wait until the inverter LED of slave 1 flashes and the Sunny Remote Control displays
To identify Slave1 press Tss on the Slv.
22. Press the start-stop button on slave 1.
☑ A signal sounds and the QCG configures slave 1.
23. Wait until the Sunny Remote Control displays To identify Slave2 press Tss on the Slv.
24. For a single-cluster system with one slave, press the button.
☑ The off-grid inverter switches to standard mode and the QCG is terminated.
25. Configuring slave 2:
• Wait until the inverter LED of slave 2 is flashing.
• Press the start-stop button on slave 2.
☑ A signal sounds and the QCG configures slave 2.
26. Press the button on the Sunny Remote Control.
☑ The off-grid inverter switches to standard mode and the QCG is terminated.
82 SI80H-60H-OffGrid-IA-en-11
SMA Solar Technology AG
Installation Manual