Stopping And Switching Off The Machine; After Completing Work; Transportation And Lashing Points - HAKO Hakomatic B45 Instruction Manual

First Operation
2.6 Stopping and switching off
the machine
Hakomatic B45
1. Stop the drive and release the safety
switch:
- The brush drive and solution supply
are switched off
2. Raise the brush head.
3. Raise the squeegee.
4. Switch off the machine with the main
switch.
Hakomatic B45 CL/CLH
1. Release the safety switch:
- The traction drive, brush drive and
solution supply are switched off.
2. Raise the brush head.
3. Raise the squeegee.
- The suction turbine continues to
run approx. 10 seconds.
4. Switch off the machine with the key
switch.
5. The machine must be protected and
secured against being started up ac-
cidentally and uncontrolled move-
ments.
2.7

After completing work

1. Drive to an appropriate maintenance
area.
2. Stop the machine and switch it off.
3. Empty the recovery tank and flush it.
Observe the applicable laws
and local regulations when dis-
posing of cleaning agents.
4. Check the solution filter.
5. Check the sealing strips and suction
hose.
6. Check the electrical equipment,
functions and settings.
7. Clean the machine.
8. Charge the batteries.
If the machine is to be shutdown for a
longer period, the solution tank must be
emptied.
It is not permitted to clean the
machine with a pressure was-
her or steam blaster.
2.8 Transportation and lashing
points
When running the machine to the site of
use, the squeegee and brush head
must be raised.
When the machine is to be transported
on another vehicle or trailer, it must be
secured against rolling away. Lash the
machine down securely. To do this, it
must be secured at the front (on both si-
des) and rear at the eye bolts (Fig. 4/1).
Fig.4 Hakomatic B45
1
13