Aleratec LightScribe Duplicator SA 260201 User Manual page 61

Stand-Alone Duplicator SA: Tutorials
Disadvantage:
▪ The loading time may have an impact on overall duplication time for small
duplication jobs.
▪ The Master Disc will be loaded to the reserve partition in the Hard Drive
temporarily until a new master is loaded and overrides the previous image.
In comparing this duplication mode with the traditional "Duplication from
Hard Drive" process, it offers the user more simplicity. By selecting the
"Load and Copy" mode via one simple touch, all the necessary tasks will
be automated for you and loaded on to the "Reserved" partition. You can
rename the data on the "Reserved" partition and place it in a standard
partition if you wish to keep it. (This must be done prior to loading a new
master through "Load and Copy)".
By default, the duplication mode is set to "Auto". This will prompt you to choose
between one of the duplication modes when you enter any of the following
functions: "Copy", "Test", "Test + Copy", and "Copy + Compare".
However, if you prefer not to be prompted each time, you can always go to "14.
Setup" and select sub-menu 9 and manually reset it. To do so, preform the following
steps:
1. Turn on the duplicator. After the bootup is complete, you will see the following
display:
2. Press the UP or DOWN button consecutively until you see following display:
3. Press ENT button once. You will see the following display:
4. Press the UP or DOWN button consecutively until you see following display:
Aleratec
1. COPY
COPY USB PRINT
Aleratec
14. Setup
COPY USB PRINT
Setup
1. Language
COPY USB PRINT
Setup
9. Duplication Mode
COPY USB PRINT
www.aleratec.com
1.00
ESC

SOURCE
1.00
ESC

SOURCE
ESC

SOURCE
ESC

SOURCE
ENT
ENT
ENT
ENT
55