Load Master Disc Onto The Hard Drive - Aleratec LightScribe Duplicator SA 260201 User Manual

Stand-Alone Duplicator SA: Tutorials

Load Master Disc onto the Hard Drive

The following steps will show you how to load your Master Disc into the installed
Hard Drive as a partition and copy the stored partition onto blank discs. This process
is recommended for mass volume production.
To load your Master Disc onto a hard drive partition, please do the following:
1. Make sure the Source is set to the Hard Drive.
It is very important to make sure the Source is set for the Hard Drive in order to
avoid unnecessary error messages. To check what the Source is set to, please do
the following:
Use UP or DOWN arrow button to navigate to the following screen.
a.
b. Press ENT to enter "Select Source" menu and you will see the following:
Make sure it is located at "Hard Drive". If not, press the UP or DOWN
arrow button to search for it. There will be drive model information where
XXXXXX is shown above.
c. Press ENT to submit your selection. After your selection has been
submitted, you will see the following display:
2. Load your Master Disc onto the Hard Drive.
Use the UP or DOWN arrow button to navigate to the following screen.
a.
24
Aleratec
9. Select Source
COPY USB PRINT
Hard Drive Port 1.0
XXXXXX
COPY USB PRINT
Aleratec
9. Select Source
COPY USB PRINT
Aleratec
11. Hard Drive Setup
COPY USB PRINT
www.aleratec.com
1.00
ESC

SOURCE
ESC

SOURCE
1.00
ESC

SOURCE
1.00
ESC

SOURCE
ENT
ENT
ENT
ENT