Overview; Unpacking The Unit; Connect The Cables And Apply Power - Aleratec LightScribe Duplicator SA 260201 User Manual

Overview

Unpacking the Unit

Your system was shipped in one box and contains the 1:3 Blu-ray/DVD/CD
LightScribe Duplicator SA and cables.
Carefully open the box and remove the top protective foam padding. Remove the
following:
• 1:3 Blu-ray/DVD/CD LightScribe Duplicator SA
• 1 Power Cord
• 1 USB 2.0 Cable
• 1 Quick Start Guide
• 1 Installation CD
Note: It is important to keep the original shipping container and packaging.
In the event you misplace your packaging and need to ship the 1:3 Blu-
ray/DVD/CD LightScribe Duplicator SA, you should first contact technical
support to purchase a new shipping container. Shipping the 1:3 Blu-ray/
DVD/CD LightScribe Duplicator SA without proper packaging will void your
warranty.

Connect the Cables and Apply Power

Plug the power cord into the power supply of the 1:3 Blu-ray/DVD/CD LightScribe
Duplicator SA, also located on the rear side (make sure the red switch is set at 115
VAC for US operation). Plug into a standard 115 VAC outlet.
Plug the USB 2.0 Cable into the USB connector located on the center rear of the 1:3
Blu-ray/DVD/CD LightScribe Duplicator SA. Connect the other end of the USB
cable into an available USB 2.0 port on your PC.
Note: Use only with a USB 2.0 port. This system cannot be used with USB
1.1, as this will greatly affect system performance. If Windows displays a
message that a fast USB device is detected on a slow USB port, then you
will need to upgrade your computer by adding a USB 2.0 port.
www.aleratec.com 7