Configure By Computer - MeiTrack MVT600 User Manual

Time zone of SMS report is separated with that of GPRS data. If you need to set time zone in GPRS data, please
use SMS command: 0000, B36, T
T=0, to turn off this function.
T=[-32768,32767] to set time difference in minutes to GMT.
For those ahead of GMT, just input the time difference in minutes directly. For example, GMT+8,
W000000,032,480
'-'is required for those behind GMT. For example, W000000,032,-120.
Example: 0000,B35,480
SMS Get: 353358017784062,B35,OK
For more details regarding SMS commands, please refer to MEITRACK SMS Protocol.

6.5 Configure by Computer

This part mainly shows you how to use the Meitrack Manager.
Note: Don't connect T1 to external battery when configuring.
Please refer to the Meitrack Manager Software for more information regarding configuration and functions.
Before using the Meitrack Manager, please first install USB driver and Meitrack Manager Software. For more
information , please read Meitrack Manager User Guide.
Run 'PL2303_Prolific_DriverInstaller' to install the driver for the USB data cable of MVT600.
Check if the USB driver is installed: Open Device Manager (right-click "My Computer" –"Manage" –"Computer
Management"- "Device Manager " ) Click "Port(COM and LPT)", and find "Prolific USB-to-Serial Comm Port" as
below. If 'Prolific USB-to-Serial Comm Port' cannot be found, you need to re-install the USB driver (for detailed
installation instructions, please refer to Meitrack Manager User Guide)
Note: Remember this Com number. It needs to be input into the Meitrack Manager. It is COM3 in this example and
it would be COM4 or COM5... in your computer.
Copyright © 2014 Meitrack Group All rights reserved.
File Name: MEITRACK MVT600 User Guide
Project: MVT600
Sub Project: User Guide
Revision: V3.1
Creator: Cavana Cheung
Creation Date:
Update Date:
Page:
Confidential: External Documentation
2010-09-13
2013-09-16
- 11 - of 25
- 11 -