Table of Contents
Advertisement
Operation
Random or erratic system operating behavior
Possible cause 1 Inadequate ventilation
Solution 1 Provide ventilation
Solution 2 Operate in safe area
Possible cause 2 Not enough memory
Solution Install memory
DigiTools either won't load or it freezes up
Possible cause DigiSuite drivers not initialized
Solution Check for errors
placed very close together and thus generate a lot of heat. It's therefore
vitally important to provide adequate ventilation.
ventilated with no obstructions blocking any openings, especially at
the rear of the unit.
computer system in areas where the temperature is above 86°F (30°C).
Do not operate it in areas with an ambient temperature above 104°F
(40°C).
system running DigiSuite, performance is drastically reduced. DigiSuite
requires a minimum of 128 MB of physical memory to perform properly.
RAM installed in your system.
DigiSuite card set won't initialize if the DigiSuite cards aren't properly
seated. This situation will leave your computer in an unstable state.
potential problems. If no errors are reported in the Event Viewer, then
turn off your computer and check to make sure your DigiSuite cards
and Movie-2 bus are properly seated. If the problem still persists after
restarting your computer, contact Matrox DigiSuite Customer Support.
The components on all DigiSuite cards are
Make sure your computer system is well
Avoid operating your DigiSuite-equipped
Without enough physical RAM installed in a
Make sure you have at least 128 MB of physical
The software drivers for the
Look in the Windows NT Event Viewer for
87
Operation
Advertisement
Table of Contents
