Table of Contents
Advertisement
Typical DigiSuite LE video connections
External
sync source
Digital video cable
Top
Digital
video
Bottom
cable
connector
Important
Make sure that you insert your DigiSuite LE analog video
cable or video breakout box cable into the proper bracket connector. Refer
to
"Identifying your connectors" on page 24
connector on DigiSuite LE.
Illustrations in the following section show some typical video connections.
In these illustrations we've connected a Program monitor (NTSC, PAL or
digital) to view the signal that will be recorded, as well as separate source
and record decks. You may, however, use the same deck as both your
source and record device by making the input and output connections to a
single deck.
Source
SDI IN
REF IN
REF LOOP OUT
SDI KEY OUT
SDI OUT
to locate the video bracket
Recorder
Typical DigiSuite LE video connections
39
Program
monitor
Advertisement
Table of Contents
