Table of Contents
Advertisement
76
Chapter 5, Configuring Your DigiSuite LE and VTR Settings
–
Manually adjust your recorder's calibration settings, if needed.
–
Stripe your tapes.
For instructions on how to perform these operations, see the following
sections.
Note
For details on how to set up RS-422 device control on DigiSuite in
Adobe Premiere RT, see the "Creating DigiSuite Effects" chapter of your
Getting the Most from DigiSuite manual.
Calibrating your recorder using the Calibration
Wizard
The Calibration Wizard guides you through a sequence of steps to calibrate
your VTR for frame-accurate recording. It records color bars, time code,
and a series of Matrox logos onto your tape, prompts you to locate the first
and last frames in the series of logos, then adjusts your VTR's calibration
settings (
Edit On Delay
Although you can manually adjust your VTR's calibration settings,
running the Calibration Wizard is the easiest way to obtain a frame-
accurate recorder.
½
To run the Calibration Wizard:
1
Set your VTR to record time code, and load a recordable tape into your
VTR.
2
Click the
Card Set 1
3
Make sure
Enable Recording
4
Click
Calibration Wizard
the screen.
5
When you've finished running the Calibration Wizard, you should test
the frame accuracy of your recorder as explained in the next section.
and
) according to your response.
Edit Off Delay
tab, then the
VTR Settings
is selected, then click
, then follow the instructions that appear on
tab.
Set Up Recorder
.
Advertisement
Table of Contents
