Table of Contents
Advertisement
56
Using the DigiSuite Configuration program
Chapter 5, Configuring Your DigiSuite LE and VTR Settings
When you ran DigiUtils Setup to install the DigiSuite software, your
DigiSuite LE was assigned default settings that are suitable for most
applications. The DigiSuite Configuration program lets you customize
these settings to meet specific video and audio input or output
requirements. For example, you may want to change the default proc amp
settings for your analog video input signal.
If you chose to install the VTR driver for DigiTools or you installed the
DigiSuite Effects plug-in for Adobe Premiere RT, you must use the
DigiSuite Configuration program to configure your VTR for RS-422
device control with these programs. This is required to perform frame-
accurate capture and recording to tape.
Important
Before starting the DigiSuite Configuration program, close
any program that uses DigiSuite, such as DigiTools or Adobe Premiere RT.
If you don't do so, your system and audio/video signals may become
unstable.
½
To start the DigiSuite Configuration program:
1
Choose
Start | Settings | Control Panel
2
Double-click the
The DigiSuite Configuration window opens, similar to this one:
icon.
DigiSuite
.
Advertisement
Table of Contents
