Table of Contents
Advertisement
Installation overview
Make sure your computer is compatible
To make sure that your computer is compatible with the DigiSuite cards
you'll be installing, refer to our web site for system recommendations. You
can find this information in the Customer Support section at:
http://www.matrox.com/video.
You can also call Matrox Video Products Group Customer Support at:
800-810-2550..................................................................... U.S. and Canada
+33 (0) 1 45 60 62 09 .........................................................................France
+49 (0) 89 61 44 74 57 ...................................................................Germany
+44 (0) 1753 665 679 ........................................UK, Middle East, and Africa
1 514 685-7230 ext. 2388 .................................................All other countries
Start with a functioning system
Before attempting any DigiSuite installation, you should have a computer
system with Windows NT 4.0 and at least Service Pack 4 fully installed
and functioning smoothly (Service Pack 5 is recommended). This will
avoid potential problems later on.
The following steps summarize the installation procedure for all types of
DigiSuite LE card sets.
Important
Please do not attempt to install your DigiSuite cards without
reading the detailed instructions on the following pages. Failure to do so
may result in broken parts and/or system malfunctions. Do it right the first
time!
1
Prepare your computer and DigiSuite LE, along with the optional
digital module and any other DigiSuite cards, for installation.
2
Open your computer and identify the expansion slots in which you'll
install your DigiSuite LE or combination of DigiSuite cards.
3
If you're upgrading to the digital module for DigiSuite LE, assemble
the card and module outside of your computer.
4
If you're installing several DigiSuite cards, carefully assemble the
cards and Movie-2 bus connector as a unit outside of your computer.
5
Insert your DigiSuite LE (and associated digital module) or assembled
Movie-2 bus-card unit in your computer.
6
Connect your external devices and configure your system BIOS.
9
Installation overview
Advertisement
Table of Contents
