Table of Contents
Advertisement
66
Chapter 5, Configuring Your DigiSuite LE and VTR Settings
Timing settings for DigiSuite LE without the digital
module
If you don't have the optional digital module, the following timing controls
are provided when you click the
Video Out
dialog box:
q
H Phase
and
Fine-tune H Phase
delay the horizontal timing of the DigiSuite LE video and key outputs
with respect to your video genlock source. This lets you compensate
for cable delays within your system. Select
use the corresponding control only if you need to fine-tune the
adjustment by subpixels.
H Phase
Important
After adjusting the
appropriate adjustment to the
q
Use this control to advance or delay the video output's
SC Phase
subcarrier phase with respect to your video genlock source.
Because of the method used to perform the SC Phase adjustment, not
all values between –180 and 180 degrees are supported. If needed, the
value you enter will be clipped to the nearest supported value.
q
Key H Phase
Use this control to advance or delay the horizontal
timing of the DigiSuite LE key output and sync signals with respect to
the video output signal. You may need to do this to align your key
images with their underlying images when routing the key output to a
downstream switcher.
To check the external key alignment, set the display source in the
DigiSuite LE Video Out
select
Graphic for Key H Phase Adjustment
button in the
Adjust Timing
Use these controls to advance or
Fine-tune H Phase
, make sure you also make an
H Phase
SC Phase
(explained below).
dialog box to
Graphic (external key)
from the
DigiSuite LE
and
, then
list.
Test Pattern
Advertisement
Table of Contents
