Table of Contents
Advertisement
Install your DigiSuite cards
q
Do not overtighten the Movie-2 bus mounting screws! Even when the
screws are properly tightened, there will be a small space between the
Movie-2 bus circuit board and the top of the cards.
q
When installing or removing your Movie-2 bus, be sure to do so in a
straight motion with no significant lateral angle. Failure to do so will
result in bent pins and/or broken connectors.
q
If you have to remove your Movie-2 bus, use a simple tool to gently
pry it loose at one end—one of the blank metal plates used to cover an
empty computer slot position works well. Then do the same with the
other end of the connector.
Note
Before proceeding, you should review the antistatic and safety
precautions described earlier on
1
If any of the slots in which you'll be installing your DigiSuite cards
already contain other cards, either move them to unused slots or
remove them completely.
2
Remove the metal plate located at the back of each slot you'll be using.
Don't lose the screws as you'll need them to fasten the cards later on.
3
Determine the order of installation for the cards. This is indicated on
the top of the Movie-2 bus. You'll install the cards from right to left
when facing the back of the computer.
4
Make sure your termination switch is set to the proper position, as
explained in
"Set the termination switch on DigiSuite LE" on page
Also, make sure you've removed the PCI retainer bracket, as indicated
in
"Removing the PCI retainer bracket" on page
page
8.
13, if necessary.
Install your DigiSuite cards
19
14.
Advertisement
Table of Contents
