Table of Contents
Advertisement
Connect DigiConnect / Video to your computer
Attach the connector on your breakout box cable to the video bracket
connector on the backplate of your installed DigiSuite LE. Tighten the
thumb screws until snug to ensure a stable connection.
Important
Do not bend the attached cable too sharply. Excessive
bending or flexing can damage the internal shielded wires.
DigiConnect/Video
Choosing your connection signal options
As you can see by reading the front panel labels, DigiConnect/Video offers
several signal options.
Note
The front switches on DigiConnect/Video are all recessed to prevent
unwanted changes. Use a small screwdriver or other appropriate object to
change the settings as required.
Video input
The DigiConnect/Video breakout box supports any of the following
combinations of video connections:
q
2 S-Video (Y/C) connections.
q
2 composite connections.
q
1 S-Video and 1 composite connection.
q
1 analog component and 1 composite connection (for this
combination, you'll have to change the IN MODE setting on the
breakout box to switch from one signal to the other, as explained in the
following section).
DigiSuite LE DigiConnect/Video breakout box
Video
bracket
connector
Audio
bracket
connector
35
Advertisement
Table of Contents
