Table of Contents
Advertisement
22
Note on removing the digital module
Chapter 2, Installing Your DigiSuite Hardware
Back of computer
13
Connect the internal video/audio cable to one of the free slots at the
back of your computer. Make sure that there are no sharp, right-angle
bends in the cable. Secure the cable's back plate to the computer.
a
Connect the appropriate power connector to your power source.
Important
Make sure you connect the power connector before starting-
up your system for the first time.
After you've connected the internal cable, close your computer's cover and
proceed to
Chapter 3, "Connecting Your External Devices and Configuring
Your BIOS Settings," on page
If you wish to remove the digital module from DigiSuite LE, keep in mind
that the male SDI connector should remain connected to the digital module
at all times. If the male SDI connector gets disconnected from the digital
module when you remove the module from DigiSuite LE, carefully
remove the connector from DigiSuite LE, then make sure you align the
pins properly before snapping it back onto the digital module. To ensure
that the pins are inserted properly, we have blocked off pin positions 24
and 54 with a key plug on the digital module female connector; the
corresponding pins on the male connector are missing.
To power
source
DigiSuite LE
Video/audio cable
23.
SDI Connector
Digital module
Advertisement
Table of Contents
