Firing modes
®
The Mastercraft
Air-powered 2-in-1 Nailer is equipped with a single sequential actuation mode
which follows the sequence for firing the fastener:
•
Press the safety stand against the workpiece.
•
Pull the trigger in order to drive the fastener.
•
If safety stand remains pressed against the workpiece, successive fasteners will fire each time
the trigger is pulled.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
•
Operate the tool with the utmost care when it is connected to the air
compressor. Failure to comply may result in moderate injury or damage to
equipment.
Fasteners depth adjustment
®
The Mastercraft
Air-powered 2-in-1 Nailer
has a depth adjustment dial below the trigger
to adjust the firing depth of the fasteners.
Note: Refer to the graphic imprinted below
the trigger and adjust the firing depth
(fig H)
accordingly
.
fig H
AIR-POWERED 2-IN-1 NAILER 058-8548-4
20
MC-588489-10