Firing Modes - MasterCraft 058-8122-6 Instruction Manual

17

Firing modes

The Mastercraft
equipped with a single sequential actuation
mode.
1. Press the safety stand (1) against the
workpiece (2)
2. Pull the trigger (1) to drive the nail with
the safety stand (2) firmly pressed
against the workpiece
3. If the safety stand remains pressed,
successive nails will fire each time the
trigger is pulled.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• The safety tip must be in contact with the workpiece before activating the
tool.
• Do not operate the tool if the nails are not loaded, as doing so may damage
the tool.
• Do not fire nails into the air, as doing so may cause injury to the operators
or others, apart from damaging the tool.
• Load the correct type of nails only. Failure to comply could lead to serious
injury or loss of life.
®
Air-powered Pin Nailer is
(fig F)
.
(fig G)
.
AIR-POWERED PIN NAILER 058-8122-6
fig F
1
fig G
1
2
2
MC-588122-08
MC-588122-09