Firing Modes; Fastener Depth Adjustment - MasterCraft 058-8489-4 Instruction Manual

CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
• Operate the tool with the utmost care when connected with air compressor.
Failure to comply may result in moderate injury or damage to equipment.

Firing modes

®
The Mastercraft Air-powered 3-in-1 Nailer is equipped with a single sequential actuation mode that
follows the steps below:
• Press the safety stand (1) against the
(fig H)
workpiece .
• Pull the trigger (2) to drive the fastener
(fig H)
.
• Lift the safety stand off the workpiece
and prepare to fire the next fastener.
• If the stand remains pressed against
the workpiece, successive fasteners
will be fired each time the trigger is
pulled.

Fastener depth adjustment

®
The Mastercraft Air-powered 3-in-1 Nailer
has a depth adjustment dial below the trigger
to adjust the firing depth of fasteners
Note: Refer to the graphic imprinted below
the trigger and adjust the firing depth
accordingly.
fig H
fig I
(fig I)
.
AIR-POWERED 3-IN-1 NAILER 058-8489-4
2
1
18
MC-588489-12
MC-588489-09