Firing Modes - MasterCraft 058-8691-0 Instruction Manual

17

Firing modes

The Mastercraft
1. Press the safety stand against the workpiece.
2. Pull the trigger in order to drive the nail with the safety tip pressed firmly against the
workpiece.
3. If the safety stand remains pressed, successive nails will fire each time the trigger is pulled.
WARNING!
Potential hazard that could result in serious injury or loss of life.
• The safety stand must be in contact with the workplace before activating the
tool.
• Do not operate the tool if the nails are not loaded, as doing so may damage
the tool.
• Do not fire nails into the air, as doing so may cause injury to the operators
or others, apart from damaging the tool.
• Do not load different sized nails into the magazine, as doing so may cause
nails to jam. Failure to comply could lead to serious injury or loss of life.
®
Air-powered Brad Nailer is equipped with a single sequential actuation mode.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
• Operate the tool with the utmost care when it is connected to the air
compressor. Failure to comply may result in moderate injury or damage to
equipment.
AIR-POWERED BRAD NAILER 058-8691-0