Clearing A Jammed Fastener - MasterCraft AIR-POWERED 2-IN-1 NAILER Instruction Manual

Clearing a jammed fastener

WARNING!
Potential hazard that could result in serious injury or loss of life.
• Disconnect the air supply from the tool before loading or changing the
fasteners.
• Disconnect the magazine from the tool and remove the non-jammed fasteners
from the tool before clearing the jammed fastener. Failure to comply could
cause them to be fired out of the tool causing serious injury.
• Do not point the tool towards the operator or other people with the trigger
pressed while loading or changing the fasteners. Serious personal injury could
result if these instructions are not followed.
To clear the jammed fastener:
• Disconnect the tool from the air supply line.
• Remove the fasteners that are stored in the tool's magazine.
• Operate the magazine release latch to open the movable magazine.
• Use pliers or any appropriate tool to remove the jammed fasteners.
• Reload the fasteners into the tool magazine.
• Close the movable magazine and verify that the magazine release latch is moved to its
original position.
• Reconnect the air supply line to the tool's air inlet.
• Test fire 3 to 5 fasteners into a piece of scrap wood in order to ensure proper operation.
Note: If the fasteners continue to jam, please call 1-800-689-9928.
AIR-POWERED 2-IN-1 NAILER 058-8548-4
22