MasterCraft AIR-POWERED 2-IN-1 NAILER Instruction Manual page 13

13
• Always use clean, dry, regulated, compressed air at 4 to 7 bar (60 to 100 PSI).
• Do not exceed the maximum or minimum pressures. Operating the tool at the inappropriate
pressure (too low or too high) will cause excessive noise or rapid wear.
Read this Instruction Manual carefully before using the Air-powered 2-in-1 Nailer
• Read and follow all the safety instructions at the beginning of this manual. Inspect the
Air-powered 2-in-1 Nailer prior to each use in order to
–
–
• It is recommended that a filter-regulator-lubricator be used and be located as close to the tool
as possible.
• If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic tool oil into the
air inlet plug before each use.
• If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the
air pressure to the tool, which will cause reduction in power, efficiency, and general
performance.
• For optimal performance, install a quick connector to the tool and a quick coupler on the
hose, if applicable.
• Verify that all of the connections in the air supply system are sealed in order to prevent air
from leaking.
WARNING!
Potential hazard that could result in serious injury or loss of life.
•
Keep hands and other parts of the body away from the tool's discharge and
working areas when connecting the air supply. Failure to comply could lead to
serious injury or loss of life.
ensure that the proper power source is being used.
verify that the tool is in proper working order.
AIR-POWERED 2-IN-1 NAILER 058-8548-4